Chrysler 2007 PT Cruiser Convertible Spezifikationen PDF herunterladen (Seite 384)

100

101

Your vehicle has a simple ignition key-actuated test,

which you can use prior to going to the test station. To

check if your vehicle’s OBD II system is ready, you must

do the following:

1. Insert your ignition key into the ignition switch.

2. Turn the ignition to the ON position, but do not crank

or start the engine.

3. If you crank or start the engine, you will have to start

this test over.

4. As soon as you turn your key to the ON position, you

will see the MILsymbol come on as part of a normal bulb

check.

5. Approximately 15 seconds later, one of two things will

happen:

a. The MIL will flash for about 10 seconds and then

return to being fully illuminated until you turn OFF

the ignition key or start the engine. This means that

your vehicle’s OBD II system is not ready and you

should not proceed to the I/M station.

b. The MIL will not flash at all and will remain fully

illuminated until you turn OFF the ignition key or start

the engine. This means that your vehicle’s OBD II

system is ready , and you can proceed to the I/M

station.

If your OBD II system is not ready, you should see your

authorized dealer or repair facility. If your vehicle was

recently serviced or had a battery failure or replacement,

you may need to do nothing more than drive your

vehicle as you normally would in order for your OBD II

system to update. A recheck with the above test routine

may then indicate that the system is now ready.

Regardless of whether your vehicle’s OBD II system is

ready or not ready, if the MIL is illuminated during

normal vehicle operation, you should have your vehicle

382 MAINTAINING YOUR VEHICLE

1 2 ... 379 380 381 382 383 384 385 386 387 388 389 ... 490 491

Kommentare zu diesen Handbüchern

Keine Kommentare

Chrysler 2007 PT Cruiser Convertible Spezifikationen Seite 384

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos Chrysler 2007 PT Cruiser Convertible