Chrysler Sebring Convertible 2010 Betriebsanweisung PDF herunterladen (Seite 13)

• Open the access port cover behind the seat where you are placing the child

restr aint.

• Push the tether strap and hook through

the access port and down into the trunk.

NOTE: Route the tether strap to provide

the most direct path from the child seat to

the anchor.

• From inside the trunk, open the access

cover on the carpet covering the back of

the seat and attach the tether strap hook

to the anchor.

• Tighten all three straps as you push the

child restraint rearward and downward into

the seat.

WARNING!

• Improper installation of a child restraint to the LATCH anchorages can lead to

failure of an infant or child restraint. The child could be badly injured or killed.

Follow the manufacturer’s directions exactly when installing an infant or child

restr aint.

• An incorrectly anchored tether strap could lead to increased head motion and

possible injury to the child. Use only the anchor positions directly behind the

child seat to secure a child restraint top tether strap.

Installing The Child Restraint Using The Vehicle Seat Belts

• To install a child restraint, first, pull enough of the seat belt webbing from the

retractor to route it through the belt path of the child restraint and slide the latch

plate into the buckle.

• Next, extract all the seat belt webbing out of the retractor and then allow the belt

to retract into the retractor. Finally, pull on any excess webbing to tighten the lap

portion around the child restraint. Any seat belt system will loosen with time, so

check the belt occasionally, and pull it tight if necessary.

• If lowered, raise the convertible top.

GETTING STARTED

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 77 78

Keine Kommentare

Chrysler Sebring Convertible 2010 Betriebsanweisung Seite 13