Chrysler Sebring Convertible 2010 Betriebsanweisung Seite 35

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 78
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 34
UNIVERSAL GARAGE DOOR OPENER
Programming HomeLink
®
Begin Programming
The HomeLink
®
buttons are located in the
sun visor.
Erase all channels before you begin
training by holding the two outside buttons
for up to 20 seconds until the red indicator
flashes.
Park your vehicle outside of the garage and turn the ignition switch to the ON/RUN
position.
Place the hand-held transmitter 1 to 3 in (3 to 8 cm) from the HomeLink
®
buttons
while keeping the indicator light in view.
Simultaneously, press and hold both the chosen HomeLink
®
button and the
hand-held transmitter button until the HomeLink
®
indicator flash rate changes
from a slow to a rapidly blinking light, then release both the HomeLink
®
and the
hand-held transmitter buttons. This may take up to 30 seconds, or longer in rare
cases.
Press and hold the just-trained HomeLink
®
button; if the indicator light stays on
constantly, programming is complete and the garage door should open.
WARNING!
Your motorized door or gate will open and close while you are training the
universal transceiver. Do not train the transceiver if people or pets are in the
path of the door or gate. Only use this transceiver with a garage door opener
that has a “stop and reverse” feature as required by Federal safety standards.
This includes most garage door opener models manufactured after 1982. Do not
use a garage door opener without these safety features. Call toll-free
1–800–355–3515 or, on the Internet, at www.HomeLink.com for safety
information or assistance.
Vehicle exhaust contains Carbon Monoxide (CO), a dangerous gas. Do not run
your vehicle in the garage while training the transceiver. Exhaust gas can cause
serious injury or death.
NOTE: If you are having difficulty training your HomeLink
®
and your garage door
opener was manufactured after 1995, you may have a rolling code. Follow the steps
below for Programming A Rolling Code System.
33
ELECTRONICS
Seitenansicht 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 77 78

Kommentare zu diesen Handbüchern

Keine Kommentare